Holeshot Tubeless Rim Tape creates a strong, airtight seal with your rim and leaves no mess behind when removed! With the perfect amount of stretch and a large, rigid recyclable core, the tape can be pulled and applied with tension, contouring tightly to your rim for a secure fit.

Key Product Features
• Constructed from high tensile strength film and primed with a bespoke adhesive
• Optimal amount of stretch and a large, rigid recyclable core, the tape can be pulled and applied with tension, tightly contouring to your rim for a perfect fit.
• The semi-translucent design makes finding the valve hole and serial numbers easy.

Our Holeshot tape is available in 10-meter rolls and four different width options: 23mm, 27mm, 32mm, and 37mm.

PRODUCT INFORMATION

WHY DID WE MAKE IT?

After several months of selling sealant, we discovered that 90% of customer service inquiries were related to issues with valves or tape. We realized we needed to create something better to reduce setup problems and give people an overall improved experience with our tubeless system.

Every aspect of this tape is designed with purpose-from the bespoke adhesive to the wide-gauge core for easier application. This truly is the bees' knees!

We thought it would be easy... We wanted an adhesive strong enough to create a reliable seal, the ability to print on the tape, and just the right amount of stretch to ensure it conforms easily to the rim bed.

BESPOKE ADHESIVE

It's easy to achieve a reliable seal by using a super strong adhesive, but if it's too strong it won't peel off the roll. It will also peel the print off the top side of the tape and leave a ton of impossible-to-clean gunk behind when removed from the rim.

To use a strong adhesive, and ensure the tape peels off itself on the roll, you can use a release coat on the top surface. This prevents the adhesive from sticking to the top surface of the tape below so it can be easily and cleanly removed. If the release coat is too strong, however, then the tape will never stick to itself when it's overlapped again on the rim. It's not an easy balance!

The resulting tape has a high tensile strength film primed with a bespoke adhesive.

DO YOU STRUGGLE TO FIND THE HOLE?

No problem! Just hold your rim up to the light, and the tape's transparent finish will illuminate the way.

 WHAT'S INCLUDED?

One 10 meter roll will cover approximately:

5x 26" Rims

4x 27.5" Rims

4x 29" Rims

4x 700c rims

NO MORE FINISHING STRIPS!

The combination of our quality tape and next-level adhesive means you no longer need finishing strips. This makes setup quicker and easier than ever before!

INSTALLATION INSTRUCTIONS

1. Remove tyre and any old rim tape - Use Disc brake cleaner to remove any grease.
2. Clean and degrease rim thoroughly, ensuring rim is completely dry before application.
3. Starting two spokes behind the valve hole, press tape firmly into the centre of the rim and smooth out to the edges, removing any trapped air.
4. Run tape around the rim while keeping tape tension, finishing two spoke holes beyond the valve hole.
5. Check for any trapped air underneath the rim tape - push air bubbles out to a spoke hole to remove
6. Use a small spike to pierce the tape in the centre of the valve hole.
7. Remove dust cap, lock ring and o-ring then push valve stem through the valve hole.
8. Re-apply the o-ring and apply lock ring tightly by hand, ensuring there are no air gaps.
9. Refit tyre, add Peaty's Tubeless Sealant.
10. Inflate tyre to desired pressure.
11. RIDE!